Specifications:
- 8 ohms 20Hz-20kHz 0.1% THD: 260W
- 4 ohms 20Hz-20kHz 0.1% THD: 425W
- 2 ohms 1kHz 1% THD: 700W
- 70V or 100V 50Hz-16kHz 0.5% THD: 500W
- 25V 50Hz-16kHz 0.5% THD: 300W
- Bridged Mono 8 ohms 1kHz 0.1% THD: 900W
- Bridged Mono 4 ohms 1kHz 1% THD: 1400W
- 140V or 200V 50 Hz-16kHz 0.5% THD: 1000W
- Signal to Noise (20Hz-20kHz): 100 dB
- Distortion (SMPTE-IM): < 0.01%
- Input Sensitivity @ 8 ohms: 1.07v (+2.8 dBu)
- Voltage Gain @ 8 ohms: 44.7x (33 dB)
- Output Circuitry: Class AB
- Distortion (Typical):
* 20 Hz-20 kHz: 10 dB below rated power: Less than 0.03% THD, 4 ohms and
- 8 ohms
* 1.0 kHz and below: full rated power: Less than 0.03% THD, 4 ohms and 8 ohms
- Frequency Response, 10dB below rated output power: 20Hz-20kHz, +0/-1dB, -3 dB points: 5 Hz + 50 Hz
- Damping Factor (Direct Outputs): > 250 @ 8 ohms
- Output Regulation: < 1.5 dB
- Input Impedance: 10 k ohms unbalanced, 20 k ohms balanced
- Input Clipping: 10 Vrms (+22 dBu)
- Cooling: Continuously variable speed fan, back-to-front air flow
- Connectors, each channel:
* Input: Active balanced; 3-pin Euro-style detachable terminal block and XLR (pin 2+)
* Output: Covered barrier strips
* DataPort V2: HD-15 connector
Controls:
* Front: AC switch
* Rear: Ch. 1 and Ch. 2 gain knobs, 10-position DIP switch
- Indicators: PWR-ON Green LED, SIGNAL Green LED (1 per channel), CLIP Red LED (1 per channel)
- Amplifier Protection: Full short circuit, open circuit, thermal, ultrasonic, and RF protection; Stable into reactive or mismatched loads
- Power Requirements: 120, 230, VAC, 50-60 Hz
- Load Protection: On/off muting; Triac crowbar: ISA 750
- Rack-mount size: 3 RU
- Dimensions: 19" x 5.25" x 15.9" (48.3 x 13.3 x 40 cm)
- Weight: 49 lbs. (22.3 kg)
